ACR Electronics Nauticast 2625 Instalační manuál Strana 37

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 83
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 36
Installation Manual 33 Y1-03-0204 Rev.K
4 Starting the NAUTICAST
Setting up your AIS Transponder for operation.
NOTE: IMO REGULATIONS MANDATE THAT YOU ENTER THIS INFORMATION.
After installing the antennas and hardware the following User, Voyage related and Ship
Settings data needs to be entered. Upon Start-up (Applying power) enter the following
information.
a) Enter MMSI Number - See paragraph 4.1 on entering information.
b) Enter IMO Number - See paragraph 4.1 on Entering information.
c) Voyage related Data After initial entry of the Voyage related Data any
changes in the information below should be edited accordingly.
See Paragraph 4.2 on entering information.
Enter Cargo Type
Enter Draught
Enter Destination
Enter ETA
Enter Navigation Status.
d) Enter Ship Settings Data - After initial entry of the Ship Settings Data any
changes in the information below should be edited accordingly. See Paragraph
4.3 on entering information.
Enter Call Sign
Enter Ships Name
Enter Length of Ship
Enter Beam of Ship
Enter Internal GPS antenna Position
Enter External GPS Antenna Position (If Applicable).
Enter Ship Type
e) Password Service and User passwords see section 4.4
4.1 Entering the MMSI and IMO Numbers:
Select from the Main Menu “Service Configuration” Number 6. Menu is SERVICE
password protected. The default password from the factory is mentioned on your AIS display
at the protection foil. Please see the appendix in your User Manual for additional password
information.. Enter Service Password and use the up and down arrows on keypad to select
“Change MMSI / IMO” than press M5 “Select” or “by pressing number 3 on the keypad.
Input your MMSI and IMO number and press Save to store data. Unit will reboot itself after
pressing Save. Continue to 4.2 after reboot, if no IMO number is available use the value 0
(Zero).
Zobrazit stránku 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 82 83

Komentáře k této Příručce

Žádné komentáře